AUTOTRIZ Bio Nano-Silver is an environmental and Eco-friendly sterilizer and disinfectant which is uniquely produced from the natural plant extracts of castor oil; fortified with Nano silver (Ag). It is formulated by an advanced biotechnology according to the European Union regulations (REACH).
AUTOTRIZ Bio Nano-Silver is a non-toxic, bio-degradable product which effectively kills the odour/bad smells, volatile organic compounds (VOC) and bacteria like E.Poli, Canadida Albicans, Aspergillus Niger, Mucar Mucedo, Penicillium citrinum, and etc., and most importantly will not affect human's health especially on maternal and child's health.
Unlike other commonly seen sterilizer in the market which covers up the odours with fragrances or kills the bacteria using toxic chemicals causing adverse effects on the environment and human's health, AUTOTRIZ Bio Nano Silver uses crystallized Nano structured silica particles of Nano silver ions (Ag+) which has the functionality of reactivity of killing odours, VOCs and bacteria with its biological mechanism when contact with water or humidity.
- Flexibility and breath-ability
- Excellent protection against graffiti / stains
- Enhances gloss
- Excellent adhesion to paint protection film
- Outstanding weather resistance
- High UV and chemical resistance
- Prevents yellowing of PPF
- Cures at room temperature
- Superior to Polysiloxane coating
PPF Flexible Coating is particularly suitable for polyurethane film, matte and satin wraps and vinyl film
PPF Flexible Coating can be applied with puff applicator for smoother application.
Density: ca. 0,86 g/cm3
Binder Base: Organic Polysilazane
Curing: Normal ambient temperature/ 80°C
Shelf Life: 12 months
Container Size: 50ml
INSTRUCTIONS FOR USE
Shake well before use.
Get ready with 3 pieces of brand new, lint-free microfiber towel. (It is recommended that new towels to be rinsed or washed with water prior to use to reduce the loosing lint)
When first applying PPF Flexible Coating on substrate, it is recommended to condition the surface of the puff applicator with 7-8 drops to prevent skipping or dry spots.
Do not work on large area at a time. It is recommended to do a 2 ft. x 2 ft. area at a time.
Apply PPF Flexible Coating using normal pressure on applicator. Make sure the area is well covered. Always start from an edge to avoid excess on other panels. Work in controlled areas to remember where you previously applied. Work in horizontal or vertical movements to ensure that product is carried through consistently.
PPF Flexible Coating is tacky and feel sticky like glue to remove. Wait for 5-10 seconds only. Use first towel to buff off the product using harder pressure.
Go immediately over with second microfiber towel with polishing motion until the film is completely free from residue.
Follow by the third towel (this is called the “insurance towel”) and go over the surface one extra time just to make sure you haven’t miss any streaks or excess residue just to make sure you haven’t miss any streaks or excess residue.
When the whole car is applied, allow curing of coating to begin. Wait approximately 30-60 minutes before applying a second layer.
Curing times depend on temperature and humidity. Curing can be accelerated using IR Lamps. Follow lamp manufacturer's recommended settings.